I-Bus 0818D, Руководство пользователя

Страница: 26 / 80

Chapter 3 - Hardware
0818D User’s Guide 3-4
insert the add-in board module on its card guides until the handle
latches begin to engage. Make sure the two guide pins mate
properly into the corresponding hole in the add-in board card
guides.
2. Engage the injector/ejector handles by pressing them towards
each other.
Note: If a firm steady pressure on the handles does not readily
seat the board, verify proper board alignment, clear insertion
path and connector pin straightness.
3. (Non-Hot swap only) Turn on the main system power and start
up the system.
(Hot swap only) The blue LED will light momentarily and should
extinguish after full insertion is complete.
4. (Hot swap only) The operating system should automatically
recognize the card and accomplish the correct steps to allocate
resources and load drivers.
5. Secure the add-in board module by tightening the two captive
screws (if they are present).
For hot swap instructions on other third party hot swap
software, consult the applicable instruction manual for the
software.
3.3 Rear I/O Transition Modules
The 0818D is configured to support rear I/O transition modules.
3.3.1 Removal of the Rear I/O Transition Modules
1. If the corresponding front I/O board has been removed as a hot
swap board, the rear I/O transition module can be removed
without powering down the system. Otherwise, it is necessary to
shut down the system and turn off the main system power to
remove the rear I/O transition module.
2. Loosen the two screws on the rear I/O module’s faceplate as
much as possible.
Note: The screws are captive to the faceplate and cannot be
completely removed. (some modules may not have screws on
the faceplate).