Hyundai N800 Series, Руководство по установке

Страница: 81 / 102

6. COMMISSIONING AND ADDITIONAL INSTRUCTIONS
75
6. COMMISSIONING AND ADDITIONAL INSTRUCTIONS
6.1 COMMISSIONING SAFETY
Before you start the commissioning, read these warnings.
WARNING!
Do not touch the internal components or the circuit boards of the drive when the drive is connected to mains.
These components are live. A contact with this voltage is very dangerous. The galvanically isolated I/O terminals
are not live.
WARNING!
Do not touch the motor terminals U, V, W or the brake resistor terminals when the drive is connected to mains.
These terminals are live when the drive is connected to mains, also when the motor does not operate.
WARNING!
Do not make connections to or from the AC drive when it is connected to mains. There is a dangerous voltage.
WARNING!
To do work on the connections of the drive, disconnect the drive from mains. Wait 5 minutes before you open the
cover of the drive. Then use a measuring device to make sure that there is no voltage. The connections of the drive
are live 5 minutes after it is disconnected from mains.
WARNING!
Before you do electrical work, make sure that there is no voltage.
WARNING!
Do not touch the relay outputs or other I/O terminals than the control I/O terminals. They can have a dangerous
voltage also when the drive is disconnected from mains.
WARNING!
Before you connect the drive to mains, make sure that the front cover and the cable cover of the drive are closed.
The connections of the AC drive are live when the drive is connected to mains.
6.2 COMMISSIONING OF THE DRIVE
Read the safety instructions in chapters 1 Safety and 6.1 Commissioning safety and obey them.
N800A