Hyundai L500 SERIES, Инструкция по установке и эксплуатации

Страница: 39 / 71

INSTALLATION & OPERATION MANUAL
L500 Series
- 38 -
ACCELERATION SENSOR AND CONTROL LEVER
!
CAUTION
YOU SHOULD PERFORM ABOVE PROCEDURES AFTER CONTROL
LEVER INSTALLATATION WITH THE ENGINE NOT RUNNING BUT
WITH THE IGNITION KEY ON.
40 mm
PROCEDURES FOR CONTROL LEVER INSTALLATION
When installing control lever cable to acceleration
sensor, be sure that the acceleration sensor lever
is fully released to the idle position and fully pulled
to the full-load position. The swing distance of lever
between idle and full-load position is 40mm.
• Idle position setting
Make sure that the position value indicates 0% in the
neutral position.
• Full load position setting
Make sure that the position value indicates full load
range of 100% at full forward lever position. If not,
disassemble and adjust the base neutral position of
the control lever by moving it to the rear until the
conditions are met.
• You can see the value of lever position on the LCD
display of rpm gauge as well as EOI.