WARNING
OPERATION OF DIESEL GENERATING SET
Interval for changing lube oil:
When starting the generator each time, should check oil level. If not
being enough, should add the lube oil to the stipulated level.
Draining off lube oil can be immediately done after engine stopped,
because it is difficult to drain off the oil thoroughly when the engine
is in cold state.
Check the air cleaner
The interval of checking the air filter and clean or replace it depend
if used in dusty emviroments we recommend as follow:
The process of cleaning the filter element is just with pressure
water, do not use chemical or detergents.
The Air filter must be complete dry before install again in the machine.
a) Open type:
A.1 Untight the screw from the cover
A.2 Remove the cover
A.3 Remove the Air filter element
A.4 Clean or replace the air filter element
A.5 Place the air filter element again in its original position
A.6 Tight all screw that fix the air element
A.7 Place the cover of the air filter and tight the screw.
b) Silent type:
B.1 Remove the cover shown in Fig.10
B.2 Process as the Open type (A.1 to A.7)
B.3 Place the cover
B.4 Tight the screws
IT IS FORBIDEN TO RUN THE GENERATOR WITHOUT AIR
CLEANER.
Checking the generator load
Unplug any power from the generator, like lamp and motor etc.
Before starting the generator, must turn off main switch (off position
of the thermal or leakage breaker). If not in this position, it is very
dangerous for the generator to be started with the load.
DO NOT START THE GENERATOR WITH LOAD
The alternator should be grounded correctly to prevent the shock
by electricity.
Checking the fuel piping
The fuel and lube oil have been removed prior to delivery. When
filling in the fuel, should check whether there is the air in the piping
before starting. If existing, should drain off the air by unscrewing on
fuel pump till no air bubbling comes out from the diesel, then
retighten the screw again.
This operation should be made only on the first start up or after the
28
ENGLISH
