Hyundai F4GE9454J*J604, Техническое и ремонтное руководство

Страница: 67 / 142

Figure 90
P roceed assembling the turbocharger:
-
Hold the turbocharger and place it on the exhaust
manifold after having interposed the gasket.
-
Screw up the fixing nuts of the turbocharger to the
exhaust manifold tightening them to the prescribed
couple.
-
Tighten the lubrication pipe fixing ring. Operate in the
same way on the other end of the pipe. Connect it to
the upper part of the heat exchanger.
To complete engine assembly it is necessary to remove it
from the turning stand.
-
Using rocker arm 99360595 hold the engine and loosen
the screws fixing the brackets to the turning stand
99322205.
-
Disassemble the brackets 99361037 from the engine
after having properly put it on a wooden bearing.
75675
1
Completion of engine
2
3
4
1
5
116386
Figure 91
On the right hand side:
-
reassemble the pipes (1) from the union (2) to the
lubrication oil filter (placed on the opposite side): tighten
the pipe rings (1) and connect them to the union
In some cases, the oil filter (3) is directly placed on
the heat exchanger: in this case it shall be
assembled using tool 99360076.
-
Reassemble the lubrication oil exhaust pipeline (1) from
the turbocharger: from underneath the turbocharger
tighten the two screws (2); tighten the screw (3) fixing
the pipeline to the block throughout the fixing collar (4)
to the block; finally tighten the union (5) to the block.
Figure 92
75671
NOTE
SECTION 3 - AGRICULTURAL APPLICATION
33
F4GE N SERIES
Print P2D32N010 E Base - February 2009