FEATURES OF YOUR HYUNDAI
1- 50
Programming
Your vehicles may require the ignition switch
to be turned to the "ACC" position for pro-
gramming and/or operation of HomeLink. It is
also recommended that a new battery be
replaced in the hand-held transmitter of the
device being programmed to HomeLink for
quicker training and accurate transmission of
the radio-frequency.
Follow these steps to train your HomeLink
mirror:
Additional Programming for Rolling
Code Devices
For any rolling-code-equipped device; follow
the steps below after completing the "Pro-
gramming" section. A second person may
make the following steps easier.
1. Locate the "learn" or "smart" button on the
device's motor head unit. The exact loca-
tion and color of the button varies by
product brand, but is usually referenced in
the device's owner's manual. Contact
HomeLink at 1-800-355-3515 or
www.homelink.com for help.
2. Press and release the "learn" or "smart"
button on the device's motor head unit.
NOTE:
You now have 30 seconds to initiate step
3.
3. Return to the vehicle and firmly press and
release the programmed HomeLink but-
ton. Press and release the same HomeLink
button a second time to complete the
training process. (Some devices may re-
quire you to press and release a third time
to complete the training.)
4. Now HomeLink mirror and rolling-code-
equipped device should be synchronized.
The remaining HomeLink buttons may now
be programmed if this has not been done
previously.
B520C02L
1. When programming the buttons for the first
time, press and hold the two outside
HomeLink buttons ( , ), releasing when
the indicator light begins to flash (approxi-
mately 20 seconds). This procedure
erases the factory-set default codes. Do
not perform this step when programming
additional transmitters.
2. Hold the transmitter of the device you want
to train 1 to 3 inches away from the bottom
of the mirror. Simultaneously press the
hand-held transmitter button and the
HomeLink button you wish to train. The
indicator light will flash slowly at first, then
rapidly, indicating successful programming.
3. If the garage door opener or other device
you wish to train is rolling-code equipped,
proceed to the "Rolling Code Program-
ming" section below.
4. Repeat step 2 to program the remaining
HomeLink buttons.
B520C03L
Flashing
Transmitter
1-3 inches
Flashing
Содержание 2002 Santa Fe
Страница 1: ...D R I V I N G IS B E L I E V I N G 2002 ...