FEATURES OF YOUR HYUNDAI
1- 23
restraint system is securely installed. If you
need to tighten the belt, pull more webbing
toward the retractor. When you unbuckle the
seat belt and allow it to retract, the retractor
will automatically revert back to its normal
seated passenger Emergency Locking usage
condition.
NOTE:
o Before installing the child restraint sys-
tem in any seating position, read the
instructions supplied by the child re-
straint system manufacturer.
o If the seat belt does not operate as
described, have the system checked
immediately by your authorized Hyundai
dealer.
WARNING:
o If the retractor is not in the Automatic
Locking mode, the child restraint sys-
tem can move when your vehicle turns
or stops abruptly.
o Do not install any child restraint system
in the front passenger seat. Should an
accident occur and cause the passen-
ger side airbag to deploy, it could se-
verely injure or kill an infant or child
seated in an infant or child seat. There-
fore, only use a child restraint system in
the rear seat of your vehicle.
B230D03E-AAT
Securing the Child Restraint Seat with
the "ISOFIX" System
B230F01O
Some child seat manufacturers make safety
seats that are labeled as ISOFIX or ISOFIX-
compatible child seats. These seats include
two rigid or webbing mounted attachments
that connect to two ISOFIX anchors at spe-
cific seating positions in your vehicle. This
type of child seat eliminates the need to use
seat belts to attach the child seat for forward-
facing child seats.
ISOFIX anchors have been provided in your
vehicle. The ISOFIX anchors are located in
the left and right outboard rear seating posi-
tions. Their locations are shown in the illus-
tration. There is no ISOFIX anchor provided
for the center rear seating position.
To install a child restraint system in the out-
board rear seats, extend the shoulder/lap belt
entirely from its retractor until a "click" is felt.
This will engage the seat belt retractor auto-
matic locking feature, which allows the seat
belt to retract but not extend. Install the child
restraint system, buckle the seat belt and
allow the seat belt to take up any slack. Make
sure that the lap portion of the belt is tight
around the child restraint system and the
shoulder portion of the belt is positioned so
that it can not interfere with the child's head or
neck. Also, double check to be sure that the
retractor has engaged the Automatic Locking
feature by trying to extend webbing out of the
retractor. If the retractor is in the Automatic
Locking mode, the belt will be locked. After
installation of the child restraint system, try to
move it in all directions to be sure the child
B230G01O-AAT
Installation on Outboard Rear Seats
B230G01L
Содержание 2002 Santa Fe
Страница 1: ...D R I V I N G IS B E L I E V I N G 2002 ...