WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
WHAT TO DO IN AN EMERGENCY
3-6
SSA3071H
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
Wheels and wheel covers may have sharp
Wheels and wheel covers may have sharp
Wheels and wheel covers may have sharp
Wheels and wheel covers may have sharp
Wheels and wheel covers may have sharp
edges. Handle them carefully to avoid pos-
edges. Handle them carefully to avoid pos-
edges. Handle them carefully to avoid pos-
edges. Handle them carefully to avoid pos-
edges. Handle them carefully to avoid pos-
sible severe injury. Before putting the wheel
sible severe injury. Before putting the wheel
sible severe injury. Before putting the wheel
sible severe injury. Before putting the wheel
sible severe injury. Before putting the wheel
into place, be sure that there is nothing on
into place, be sure that there is nothing on
into place, be sure that there is nothing on
into place, be sure that there is nothing on
into place, be sure that there is nothing on
the hub or wheel (such as mud, tar, gravel,
the hub or wheel (such as mud, tar, gravel,
the hub or wheel (such as mud, tar, gravel,
the hub or wheel (such as mud, tar, gravel,
the hub or wheel (such as mud, tar, gravel,
etc.) that interferes with the wheel from
etc.) that interferes with the wheel from
etc.) that interferes with the wheel from
etc.) that interferes with the wheel from
etc.) that interferes with the wheel from
fitting solidly against the hub. If there is,
fitting solidly against the hub. If there is,
fitting solidly against the hub. If there is,
fitting solidly against the hub. If there is,
fitting solidly against the hub. If there is,
remove it. If there is not good contact on the
remove it. If there is not good contact on the
remove it. If there is not good contact on the
remove it. If there is not good contact on the
remove it. If there is not good contact on the
mounting surface between the wheel and
mounting surface between the wheel and
mounting surface between the wheel and
mounting surface between the wheel and
mounting surface between the wheel and
hub, the wheel nuts could come loose and
hub, the wheel nuts could come loose and
hub, the wheel nuts could come loose and
hub, the wheel nuts could come loose and
hub, the wheel nuts could come loose and
cause the loss of a wheel. Loss of a wheel
cause the loss of a wheel. Loss of a wheel
cause the loss of a wheel. Loss of a wheel
cause the loss of a wheel. Loss of a wheel
cause the loss of a wheel. Loss of a wheel
may result in loss of control of the vehicle.
may result in loss of control of the vehicle.
may result in loss of control of the vehicle.
may result in loss of control of the vehicle.
may result in loss of control of the vehicle.
This may cause serious injury or death.
This may cause serious injury or death.
This may cause serious injury or death.
This may cause serious injury or death.
This may cause serious injury or death.
D060H02A-AAT
7. Reinstall Wheel Nuts
7. Reinstall Wheel Nuts
7. Reinstall Wheel Nuts
7. Reinstall Wheel Nuts
7. Reinstall Wheel Nuts
YL30140A
To reinstall the wheel, hold it on the studs, put
the wheel nuts on the studs and tighten them
finger tight. The nuts should be installed with
their small diameter ends directed inward. Jiggle
the tire to be sure it is completely seated, then
tighten the nuts as much as possible with your
fingers again.
D060G02Y-AAT
6. Changing Wheels
6. Changing Wheels
6. Changing Wheels
6. Changing Wheels
6. Changing Wheels
SSA3070H
Loosen the wheel nuts and remove them with
your fingers. Slide the wheel off the studs and
lay it flat so it cannot roll away. To put the wheel
on the hub, pick up the spare tire, line up the
holes with the studs and slide the wheel onto
them. If this is difficult, tip the wheel slightly and
get the top hole in the wheel lined up with the
top stud. Then jiggle the wheel back and forth
until the wheel can be slid over the other studs.
Содержание 2002 Santa Fe
Страница 1: ...D R I V I N G IS B E L I E V I N G 2002 ...