TC-265/365 SERVICE MANUAL
-
11
-
5.4 PC Adjust Mode
The following parameters can be adjusted through PC (only for factory adjustment):
Adjustment data;
Maintenance record.
5.5 Wired Clone Mode
Turn the radio on while holding down the [MONI], after two seconds, a beep sounds and red LED flashes
indicating that the radio enters wired clone mode.
Operation:
(1) Press [PTT] to begin cloning and red LED flashes.
(2) Short out the clone mode points FCPY on PCB to enter factory clone mode.
(3) Disconnect the clone mode points FCPY on PCB to enter dealer clone mode.
(4) You can clone the following data in wired clone mode:
General parameter;
User channel data;
Factory channel data; (only available in factory clone mode)
Center, low and high frequency; (only available in factory clone mode)
2-Tone frequency;
5-Tone frequency;
Adjustment data; (only available in factory clone mode)
5.6 User Mode
Turn the radio on, a beep sounds and green LED flashes indicating that the radio enters user mode. This
mode is used for normal operation.