Hyster B218, Периодическое техническое обслуживание

Страница: 17 / 26

8000 SRM 1009 Recommended Schedule of Maintenance
LUBRICATION CHECK
Blow off, clean when necessary, and inspect for damage.
A - Every 8 Hours
B - Every 350 Hours
C - Every 2000 Hours X - Indicates Visual Inspection, Repair, or
Replace as Required
O - Indicates Drain and Fill
Component: A B C
Lubricate - Chassis (All Fittings) X
All Linkage and Load Wheels (See Note 2) X
Clean and Repack Load Wheel Bearings X
Hydraulic Reservoir Oil Level X O
Hydraulic Reservoir Breather X
Caster Wheel Clearance X
Drive Unit Oil Level (See Note 5) X O
NOTES:
1. Tires - Condition affects stability, safety, and load capacity that can be handled safely.
2. Under Normal Conditions, it is recommended that the Load Wheel Bearings be lubricated every 200
hours, minimum. The load wheel bearings are cleaned and repacked every 2000 hours. For trucks equipped
with the Food Processing Package or operate under Wet or Corrosive Conditions, it is recommended
to lubricate the lift linkage every 50 hours. Load wheel bearings should be inspected every 350 hours.
3. See Capacities and Specifications 8000 SRM 1010 for all lubrication specifications.
4. The presence of hydraulic fluid on cylinder rods and fittings does not necessarily indicate a leak.
5. Drain and refill drive unit gear oil after initial 350 hours of operation.
6. Recycle all waste oils.
HYDRAULIC SYSTEM CHECK
A - Every 8 Hours
B - Every 350 Hours
C - Every 2000 Hours X - Indicates Visual Inspection, Repair, or
Replace as Required
O - Indicates Drain and Fill
Component: A B C
Hydraulic Pump for Noise and Operation X
Hydraulic Control Valve for Leaks and Operation X
Relief Valve Settings X
NOTES:
1. Tires - Condition affects stability, safety, and load capacity that can be handled safely.
2. Under Normal Conditions, it is recommended that the Load Wheel Bearings be lubricated every 200
hours, minimum. The load wheel bearings are cleaned and repacked every 2000 hours. For trucks equipped
with the Food Processing Package or operate under Wet or Corrosive Conditions, it is recommended
to lubricate the lift linkage every 50 hours. Load wheel bearings should be inspected every 350 hours.
3. See Capacities and Specifications 8000 SRM 1010 for all lubrication specifications.
4. The presence of hydraulic fluid on cylinder rods and fittings does not necessarily indicate a leak.
5. Recycle all waste oils.
13