Hyster A935 J1.6-2.0XN, Руководство по обслуживанию и ремонту

Страница: 16 / 25

Carriages Repair
STANDARD CARRIAGE
Remove
1.
Remove the forks. See Fork Replacement.
2.
Remove four socket head capscrews and remove
the load backrest. See Figure 8.
3.
Connect a lifting device to the carriage. Lift the
carriage so that the lift chains become loose.
WARNING
When disconnecting the lift chains, keep control
of the ends. Use wire to temporarily connect the
ends of the lift chains to the mast. This procedure
will prevent the lift chains from falling and caus-
ing an injury or damage.
4.
Remove the chain pin from each chain anchor
at the carriage. See Figure 9. Disconnect the lift
chains from the carriage. Use wire to connect
the ends of the lift chains to a part of the mast.
Make sure the chains can move freely when the
inner mast is raised.
NOTE: TWO-STAGE LFL CARRIAGE SHOWN.
LOAD BACKREST IS MOUNTED THE SAME WAY
ON THREE-STAGE FFL CARRIAGE
1. SOCKET HEAD CAPSCREW
2. WASHER
3. NUT
4. CARRIAGE
5. LOAD BACKREST
Figure 8. Load Backrest Removal
Carriages Repair 4000 SRM 1386
10