HySecurity HTG 320-2, Руководство по установке и обслуживанию

Страница: 31 / 69

Installation and Maintenance Manual
23
Description of Functions Available in the User Menu
User 1
[Ct _]
Close timer setting:
This menu item is the automatic close timer for the gate. The
factory setting is zero, which is off. It may be configured up to 99 seconds.
User 2
[hC 0]
Momentary Close:
This menu item is to configure for the system for constant hold push
button Close function. The factory setting is zero, which is momentary contact input.
User 3
[ho 0]
Momentary Open:
This menu item is to configure for the system for constant hold push
button Open function. The factory setting is zero, which is momentary contact input.
User 4
[AP 0]
Power loss function:
This menu item only appears if the operator is a DC battery
powered version. This item is to configure what gate function will occur when the AC power fails. See
the two part operator section for more detailed information on DC operators.
User 5
[ro 0]
Radio control option:
This menu item is to configure whether a radio input can open
only (default) or if set to 1, also has the ability to close the gate, but only when it is fully open.
User 6
[bF 2]
Warn before operate:
This menu item controls the optional accessory warn before
operate buzzer and can be configured three ways. Set to zero to turn the buzzer off, never cut the wires
to the buzzer or unplug it. Set to 1 and the buzzer will sound three seconds before motion and the
entire time during gate motion. Set to 2 (default) and the buzzer will sound three seconds before motion
and for the first two seconds of motion.
User 7
[FA 0]
Forced open Alert and automatic gate reposition:
This function is intended for highly
secure facilities. If it is enabled, by setting the selection to 1, it will reinitiate a closure if a gate is
somehow forced to open far enough that the close limit switch releases. The Alert buzzer will sound
immediately, even if it had been turned off, and the motor will restart to secure the gate fully closed. If
the gate is not fully closed within four seconds the motor turns off and the alert buzzer sounds an intruder
alert for thirty seconds. The LCD display reads ALE1.
User 8
[dA 0]
Drift Closed Alert and automatic gate reposition:
If it is enabled, by setting the
selection to 1, it will restore a gate to back its fully open position if it drifts closed for any reason. The
buzzer will sound a warn before operate alert, even if it had been turned off, and the motor will restart to
reopen the gate. The motor will run for a maximum of four seconds and if the gate is not fully open in
this period, the buzzer sounds for ten seconds and the LCD display reads ALE2.
User 9
[PE 0]
PE Alignment Mode:
When activated, the buzzer chirps as the photo eye is triggered
or released as an aide to photo-eye emitter / receiver alignment.
User 10
[CL 0]
Clock and date set:
The Smart Touch Controller is equipped with a 24 hour 365 day
clock, so that events of significance can be logged and stamped with the time and date. This feature is
useful to record historical operation data, which can be accessed via the RS232 port. To set or adjust
the hour, minute, day or month, see page 27.
User 11
[Ld 5]
LCD Contrast set:
Under some extreme high or low temperature conditions, it may be
necessary to adjust the contrast of the LCD display. The display is adjustable from 0-9 with a factory
default setting of 5.
User 12
[dD 0]
Extended Data Log:
When set to 1 the ST Controller logs additional events within the
Smart Touch Controller in addition to the normal error and alert logs. This parameter resets to 0
automatically after 24 hours – (Requires New Generation Smart Touch board and V4.xx software)