FRONT AND REAR WHEEL REMOVAL
1. Place the vehicle on level groud and set the
parking brake.
2. Loosen the three wheel nuts
①
on the wheel
to be removed.
3. Lift up the front or rear end of the vehicle by
placing a jack or block under the axle or
frame.
4. Remove the three wheel nuts.
5. Remove the wheel. To reinstall the wheel,
reverse these steps.
37
The slack in the drive chain to 5~15mm
(0.197~0.591 in).
If exceed 15mm (0.591 in) of the drive chain
slack, replace the drive chain with a new one.
Failure to inspect the drive chain slack
before each use of the vehicle could be
hazardous. Too much chain slack could
cause the chain to come off the
sprockets, resulting in an accident or
serious damage to the vehicle.
Inspect the drive chain slack before
each use.
WARNING
When replacing a wheel, it is very
impotant that the wheel axle nuts be
torqued to the proper specifications. If
they are not, the wheel can come off
unexpectedly. We strongly recommend
that you have these nuts checked and
retorqued, if necessary, by your autho-
rized HYOSUNG dealer.
WARNING
Tighten Tirque
25 N
∙
m
(2.5
㎏∙
m)
FOOTREST HEIGHT ADJUSTMENT
Front and Rear
wheel nut
①
①
②
③
④
This vehicle is equipped with a footrest lower
bolts
①
.
To adjust height of the footrest, perform the fol-
lowing :
1. Remove the footrest screws
②
.
2. Remove the footrest bolts
③
.
3. Remove the footrests
④
, right and left.
4. Install the footrest lower bolts
①
.
5. Install the footrests
④
, right and left.
6. Tighten the footrest bolts
③
.
7. Tighten the footrest screws
②
.
COPYRIGHTED
Содержание TE 50
