Hylio Agrodrone (AG-122) Maintenance Manual
©2020 Hylio Inc. All Rights Reserved
9
-
Pump wire not damaged
(check closely at mount points and where wire enters frame)
Pneumatic Spray
System Tubing
-
No leaks in tubing when spraying at max pressure
-
Tubing clean of chemical residue
Nozzle Body
-
No leaks when spraying at max pressure
-
No cracks in plastic nozzle body
-
Internal filter clean and undamaged
Two 3 Gallon Tanks
-
No leaks when tank is full (check tank outlet nipple and bottom
cap)
-
No cracks or damage to plastic
40 mm Carbon Fiber
Tubes (Arms)
-
No visible cracks in carbon fiber tubes
-
All screws tight and rust free
Arm Elbow Joint
-
5 mm pin bolt EXTREMELY tight (check torque)
-
No cracks in composite housing
-
All screws tight and rust free
Aluminum Landing
Gear and Mounts
-
No visible cracks or incorrect bends in aluminum legs frame.
Drone does not wobble when sitting on landing gear
-
All screws tight and rust free
Plastic Guard
-
Guard fastener screws tight and rust free
-
No large cracks or visible damage
Internal Components
-
Take off plastic shell top: inspect inside center frame for damage
-
All connectors plugged in tight
-
No loose dangling wires
-
No signs of damaged components or electrical shorts
Battery Trays
-
All screws on inside and outside of trays tight and rust free
-
Battery connector on drone side clean on inside and all screws
tight and rust free
Batteries
-
Battery case does not have dents, connector wires do not show
wear or fray
Threaded Arm Clamp
-
No cracks in plastic
-
Threads still hold tight
Micro USB Connector
-
Clean and free of debris inside connector
-
Not loose in housing
-
Rubber cap in place
Flowmeter Filters
-
No cracks in plastic housing
-
No leaks from filter
-
Filter mesh clean
Top Plastic Covers
-
No cracks or other visible damage on plates
-
All screws tightened to listed torque
All unnamed fasteners -
All tightened to listed torque
