HYKKER
EN
44
Emergency reset of the
device in case of lack of
control using a remote
control
or
phone
application.
In extreme cases where there is no control over the
device, the device parameters can be reset by
disconnecting the battery. To do so, turn off the system
by holding down the power button for a few seconds until
the LEDs switch off. Unscrew the battery cover and
gently disconnect the battery cable plug from the
mainboard socket. After a few minutes, plug the battery
cable plug into the mainboard socket, insert the battery
into the compartment, attach and tighten the battery
compartment cover.
If the problem persists, contact the manufacturer's service department.
You can obtain a free printed version of the
manual with the large font size or download
it from the web address below:
www.mptech.eu/qr/hykker
or by scanning the QR code.
The warranty terms and conditions can be
found on the website:
www.mptech.eu/gwarancja
STORAGE OF EQUIPMENT
The device is usually connected to a docking station. If you are not going to use the
device for a long time, after turning it off with the power button (2), cleaning the rubbish
container and cooling down, store it in a dry room away from heat and moisture
sources. It is best to place the device in its original packaging, away from children and
pets.
TRANSPORT OF THE DEVICE
It is recommended to transport the device in its original packaging after it has been
switched off. Do not expose the unit to excessive vibration or shock during
transportation. When in use, only move the unit after it has been switched off, holding
the unit by its base with both hands.
11. STORAGE AND TRANSPORT
