Hydrotech 89BM-100, Инструкция по установке и эксплуатации

Страница: 6 / 19

6
•
Place the filter tank as close as possible to
the pressure tank (well system) or water
meter (city water).
•
Place the filter tank as close as possible to
a floor drain, or other acceptable drain
point (laundry tub, sump, standpipe, etc.).
•
Connect the filter to the main water supply
pipe BEFORE the water heater.
DO NOT
RUN HOT WATER THROUGH THE FIL-
TER
. Temperature of water passing
through the filter must be less than 100
deg. F.
•
Do not install the filter in a place where it
could freeze.
Damage caused by freez-
ing is not covered by the warranty.
•
Put the filter in a place water damage is
least likely to occur if a leak develops. The
manufacturer will not repair or pay for wa-
ter damage.
•
A 120 volt electric outlet, to plug the in-
cluded transformer into, is needed within 6
feet of the filter. The transformer has an
attached 6 foot power cable.
Be sure the
electric outlet and transformer are in
an inside location, to protect from
wet weather.
•
If installing in an outside location, you
must take the steps necessary to assure
the filter, installation plumbing, wiring,
etc., are as well protected from the ele-
ments, contamination, vandalism, etc., as
when installed indoors.
•
Keep the filter out of direct sunlight .
The sun’s heat may soften and distort
plastic parts.
Where To Install The Filter