Page 13
autocut 5-20l user manual edItIon I 2014-05-23
5.8 Air pressuire regulation
1. Belt pressure regulator.
allways use as low pressure as possible. If the belts slip, increase the pressure. as starting
point we recommend 2 bar.
2. Measuring wheel regulator.
always use as low pressure as possible. If the wheel slips, increase the pressure. as star-
ting point we recommend 1,2 bar.
5.9 Cutting blade height adjusting
adjust the cutting blade height by loosen the knob and move it up and down. the height
should be adjusted so the blade just cuts through the hose. If the blade travels to long
the cut might be out of angle, if it travels to short it doesn’t cut the hose. note the posi-
tion on the scale and keep a record for the different types of hoses.
5.10 Start up
1. turn on the main switch on the electric box.
2. release the emergency stop by turning it clockwise.
3. press the reset button.
4. turn the rev-fwd knob any direction to activate the driving belts and the measuring
wheel. first time the knob is turned the belts and the measuring wheel is activated. se-
cond time the knob is turned the driving belts will start to drive.
5. enter wished parameters by using the touch screen. (see programming instructions)
6. press start.
HYDROSCAND MACHINE AB
Kungsvägen 22
Phone: +46 (0)225 - 57 330
S-783 35 Säter
Fax:
+46 (0)225 - 50 108
Sweden
Web:
www.hydroscand-machine.se
MANUAL -E
Page 14
6.8 Air pressure regulation
1
2
1.
Belt pressure regulator.
Allways use as low pressure as possible. If the belts slip,
increase the pressure. As starting point we recommend 2 bar.
2.
Measuring wheel regulator.
Always use as low pressure as possible. If the wheel
slips, increase the pressure. As starting point we recommend 1,2 bar.
6.9 Cutting blade height adjusting
Adjust the cutting blade height by loosen the knob and move it up and down. The height
should be adjusted so the blade just cuts through the hose. If the blade travels to long the
cut might be out of angle, if it travels to short it doesn't cut the hose. Note the position on
the scale and keep a record for the different types of hoses.
HYDROSCAND MACHINE AB
Kungsvägen 22
Phone: +46 (0)225 - 57 330
S-783 35 Säter
Fax:
+46 (0)225 - 50 108
Sweden
Web:
www.hydroscand-machine.se
MANUAL -E
Page 14
6.8 Air pressure regulation
1
2
1.
Belt pressure regulator.
Allways use as low pressure as possible. If the belts slip,
increase the pressure. As starting point we recommend 2 bar.
2.
Measuring wheel regulator.
Always use as low pressure as possible. If the wheel
slips, increase the pressure. As starting point we recommend 1,2 bar.
6.9 Cutting blade height adjusting
Adjust the cutting blade height by loosen the knob and move it up and down. The height
should be adjusted so the blade just cuts through the hose. If the blade travels to long the
cut might be out of angle, if it travels to short it doesn't cut the hose. Note the position on
the scale and keep a record for the different types of hoses.
