HYDROSCAND AutoCal H24D, Руководство пользователя

Страница: 11 / 44

H24/H32D AutoCal USER MAnUAL EDiTiOn i 2013-02-27
11
4. start-up
4.1 Machine placement
place the machine on a stable and flat surface. Adjust the machine’s feet so that they cannot
be over-turned or fall from the surface. if the optional die stand is used, the machine must
be bolted to the die stand and the stand bolted to the floor.
4.2 electrical installation
The machine is delivered without cables or contact plug. Contact a qualified electrician for
electrical installations. Make sure that the mains voltage is the same as the marked voltage
on the machine before it is plugged in.
note!
check the rotational direction of the motor.
4.3 Filling the oil
H24D/H32D AutoCal is delivered with an empty 24 liter oil tank. Fill the tank to the indi -
cator mark on the oil stick. Use only the oil recommended by Hydroscand Machine AB.
Recommended oil: iSO vG46
4.4 selecting dies
Determine the crimping dimensions for the current operation and select the die set with the
correct interval that corresponds to the crimping measurement.
For example: A crimping measurement of 17 mm requires the die set size nr 16 (since it covers
the 16-19 mm interval).
Always select the die set within the correct interval to achieve the
best crimping results. Every die is marked with the smallest crimping measurement in the
interval.
note!
Crimping any measurements outside the table crimping measurement interval is not recom -
mended. Using dies that are too small risk the ferrule becoming oval.
4.5 setting crimping measurements
A die set table is mounted on the machine to indicate the crimping measurement intervals
for each die set. Crimping measurements that lie outside of the interval is not recommended.
The set crimping measurement can differ from the actual physical crimping measurement
due to the crimped material expanding a bit when released as well as expansion in the
machine. This is compensated by making adjustments.