User Program No ET
To program without ET, you must figure out the entire irrigation
schedule (cycle time, number of cycles per operating day, soak time
and days of operation) and enter it into the controller.
Unless you change it, the schedule remains the same.
This mode is different from the “User Programmed—With ET Mode”
in that the irrigation schedule is not modified by the daily ET
Everywhere Service updates. Stations in this mode will run according
to the Start Times that you entered in “Setup.”
Remember that stacking is a sequential operation and non-stacking is
a simultaneous operation.
Note:
The steps to program your controller without ET are the same
as programming with ET.
Follow the same steps for programming with ET if you wish to
program without ET.
Copying
This feature lets you copy the information you entered for one station
to another station, multiple stations, or all stations. The information
can then be edited as required. This speeds up programming and
minimizes your chances for error.
Occasionally, you may wish to erase all of the programming you
entered in your WeatherTRAK ET plus controller and start over. You
can easily do this with “Copy Program Defaults.” Or, you may want
to start over with the “Setup” defaults. You can do this by using
“Copy Setup Defaults.”
The steps to use the “Copy” feature include:
1.
Copy From the Station Number
Set the source station with the Upper Line dial.
2.
To Station Number (Press COPY)
Set the destination station(s) with the Lower Line dial, then press
the “Copy” button.
Programming Your WeatherTRAK ET Plus
49
For “Water 7 Days Per Week”:
Turn the Upper Line dial until you see:
There are no other choices. The entry process is finished. You can
now program additional stations or use the COPY function to copy
programs between stations.
For “Set Water Day Intervals”:
1.
Turn the Upper Line dial until you see:
2.
Turn the Lower Line dial to:
•
01 to 31 (Default Setting: 01).
3.
Turn the Upper Line dial until you see:
After the irrigation interval is set, the entry process is finished. You
can now program additional stations, or use the COPY function to
copy programs between stations.
PROGRAM COMPLETE STA 02
WATER DAY INTRVL STA 02
01 Day (water everyday)
SCHEDULE COMPLETE STA 02
Programming Your WeatherTRAK ET Plus
48
