Page 4-5 : CTS 450 Owner’s Manual
Hot Carbonating Truckmount System
CTS 450
Blower
Quick Reference List
Check blower level.
Drain oil.
Fill oil.
Lube blower.
Blower Oil Change
The vacuum blower has two sight glasses for
checking the oil level. One is located in the rear of the blower
(
Figure 4-10
) and the other is towards the front near the bell
housing. The oil level should be checked daily to ensure that
it reaches over half the sight glass.
1. Remove the two oil drain caps, which are located on right
center bottom side of the machine.
2. Remove oil fill caps.
3. Fill the blower with 40W non-detergent oil. After oil
begins to flow out of the oil drain fitting, re-install the caps.
This will allow air to evacuate from the system and give
accurate oil level reading.
Failure to do this step will result in an insufficient
amount of oil in the blower will lead to damage or failure!
4. Re-install the oil fill plugs.
Tools
11/16 wrench
Figure 4-10
WARNING
!
Figure 4-12
Figure 4-11
Содержание CTS 450
