HydraMaster CTS 450, Руководство пользователя

Страница: 31 / 119

Page 2-7 : CTS 450 Owner’s Manual
Hot Carbonating Truckmount System
CTS 450
CAUTION
!
CAUTION
!
CAUTION
!
Compressor System
The compressor pump in this machine is also referred to as an oil-less reciprocating
piston pump. The performance and life of this unit is greatly dependent on the care and
proper maintenance it receives.
The compressor is belt and clutch driven. The clutch is controlled by the pressure
switch located on the front panel. The compressor operates as follows:
„
With the cleaning mode switch in “Cleaning Mode”
and the pressure in the solution tank is below the
set point, the pressure switch will activate the
clutch.This allows the compressor to turn and
pressurize the system.
„
With the cleaning mode switch in “Cleaning Mode”
and the pressure in the solution tank is above the
set point, the pressure switch will deactivate the
clutch. This will turn off the compressor.
„
With the cleaning mode switch in “Extraction Mode”
the clutch will turn off regardless of the pressure in
the solution tank.
The compressor should be well ventilated. Objects place
or installed adjacent to the pump will significantly reduce the life of the pump
Filtration: Periodically check the inlet air filter. To clean filter, disassemble filter housing
and use compressed air to blow dirt particles from the filter element. Replace filter
when element can no longer be cleaned with this method
Do not operate without an inlet air filter. Excessive dirt, foreign particles, moisture, or
liquids entering the pump can contribute to poor performance and/or premature failure.
Dirty filters reduce pump performance by restricting air flow.
Lubrication: The CTS 450 compressor is a dry, oil-less compressor. The product uses
sealed grease packed bearings and does not require additional lubrication
DO NOT LUBRICATE. Adding grease products to this unit will reduce performance and
can potentially damage the product.
Figure 2-6