HydraMaster Boxxer 423s, Руководство пользователя

Страница: 24 / 92

3-9: Cleaning Information Cleaning Information: 3-8
RX-20 Tool for Carpet, Hard Surface and Bonnet Cleaning
Before turning on the RX-20, adjust the handle; it should rest right below or even with the
bottom of your pants’ front pockets, with the tool resting flat on the floor. Take your time
in adjusting the tool’s height; make sure the head of the tool is flat with the floor while you
are holding the handle. Relax your posture; the more difficult it is to hold the tool’s head
flat on the floor surface, the more quickly you will tire.
While the tool is running, control the left and right movements of the tool by tilting the head
to the front and back, and lifting the handles up and pushing the handles down. The tool
can be driven to the forward and backward by tilting the head of the unit to the left and
right. The head must be turning to use the self driving feature of the tool, and only requires
a slight bit of pressure to handles to get the head to move the tool across the floor.
As with the wand, drying times will be improved if you run a dry pass between wet passes.
Hold down the solution trigger and move the unit left or right across the floor 3 or 4 ft, then
immediately back across the same pass, without the solution flowing, to make the dry
pass. Make the next pass half-overlapping the previous pass.
Use the RX-20 in very heavily trafficked areas or if it has been a long time since the carpet
has been cleaned. Beware of the seam edges of carpets and transition edges between
floor surfaces. Use extreme caution when cleaning these areas.
Sometimes it is necessary to use an edge tool or wand to run the perimeter of the room
on in difficult-to-reach areas where the circular head of the rotary units will not reach.
The 5 vacuum heads and 3 jets
rotate at 130 rpm, creating
650 complete cleaning
passes per minute.
For Truckmount or Portable
Carpet Cleaning Systems
• Aggressive restorative extractor tool
for carpet, hard surface and bonnet
cleaning
• Labor-saving, ergonomic design
• Superior agitation for cleaning
stains, heavily soiled and
matted carpet
• Durable construction for long
life
• Reduces fatigue of the
operator
Upholstery Tool - DriMaster 3
Use the upholstery tool on small rugs and furniture. When you clean rugs, be sure that the
temperature and chemicals are safe for that particular type of rug.
As with the larger tools, do not leave the surface of the upholstery too wet. Adjust the
volume of water on the tool without it touching any surface: the water should just barely
come out of the tool before the vacuum pulls it back in. The water will only just spray the
top layer of the furniture and the vacuum will pull the dirty water back into the tool.
If you find it necessary to do a dry pass, keep strokes short to limit the amount of water
that comes into contact with the fabric surface.