Hydralok H19MM, Руководство пользователя

Страница: 13 / 15

13
LUBRICATON
The swaging head must be lubricated at least every 350 swage cycles. To apply the
grease, ensure that the machine is fully open. Lubrication is easily done with a small clean
brush ensuring that the inside of the swaging ring (chromed moving piston) and flat face of
the die holders are evenly coated with grease (see below).
Fig. 6
PROCEDURE TO BLEED THE SYSTEM
Close the pump operating knob and operate the pump until the piston in the swaging
machine moves 15-20mm. Position the machine in the vertical plane and loosen the bleed
screw (item 12) located in the center of the top face of the piston. (DO NOT REMOVE). Air
trapped in the system will escape through the bleed screw. When oil appears from the
bleed screw and no more air is expelled, retighten the bleed screw. This operation may
need to be repeated should there be excessive air in the system. It is advisable to check
the oil level in the pump after the bleeding operation.
Lubrificare qui
!
VERY IMPORTANT!
Lubrication is the most important factor that affects the performance of
your Hydralok
swaging machine
. It is vital that the machine is regularly
lubricated using a high-performance grease based on molybdenum
disulphide.
Lack of lubrication or the use of other types of lubricants
could cause irreparable damage to the machine.