Hydor AQAMAI LF, Руководство пользователя

Страница: 4 / 16

4
SAFETY WARNINGS
DANGER
- To avoid possible electric shock, special care should be taken in the
use of aquarium equipment. For each of the following situations, do not
attempt repairs yourself; return the appliance to an authorized service
facility for service or discard the appliance.
- DO NOT look directly at LEDs regardless of intensity.
- This product carries an ingress protection rating of IP20 and must not
be submerged into the water.
- To avoid possible electrical shock, special care should be taken since
water is damaging to aquarium equipment.
- DO NOT attempt repairs yourself; return the appliance to the manufacturer
for service or discard.
- DO NOT immerse in water. If the appliance falls into the water, DON’T reach
for it! First unplug it and then retrieve it. If electrical components of the
appliance get wet, unplug the appliance immediately (non-immersible
equipment only).
- Carefully examine the appliance after installation. It should not be plugged
in if there is water on parts not intended to be wet.
- LR/LF is NOT WATERPROOF; water can permanently damage it. This
damage IS NOT covered under warranty. Protect these components from
splashes, drips or other contact with water.
- Do not operate any appliance if it has a damaged cord or plug, if it is
malfunctioning or if it is dropped or damaged in any manner. The power
cord of this appliance cannot be replaced: If the cord is damaged, the
appliance should be discarded. Never cut the cord. DO NOT DROP. LR/LF
is fragile, and a fall onto a hard surface can result in permanent damage.
Damage from dropping IS NOT covered under warranty.
- Position the aquarium stand and tank to one side of a wall-mounted
socket to prevent water from dripping onto the socket or plug. A “drip loop”
should be employed for each cord connecting an aquarium appliance to a
socket. A “drip loop” is the part of the cord below the level of the socket (or
the connector if an extension cord) to prevent water from travelling along
the cord and coming in contact with the socket. If the plug or socket does
get wet, DON’T unplug the cord. Disconnect the fuse or circuit breaker that
supplies power to the appliance, then unplug and examine for presence
of water in the socket.
- The appliance is not to be used by children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction.
- Always unplug appliance from outlet when not in use, before putting on
or taking off parts and before cleaning.
- Never yank cord to pull plug from outlet. Grasp the plug and pull to
disconnect.
- Do not use appliance for other than intended use. The use of attachments not
recommended or sold by the manufacturer may cause an unsafe condition.
- Do not install or store the appliance where it will be exposed to weather
or to temperatures below freezing.
- Make sure appliance is securely installed before operating it. Read and
observe all the important notices on the appliance.
- If an extension cord is necessary, a cord with a proper rating should be
used. A cord rated for less amperes or watts than the appliance rating
may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
- Do not operate the LR/LF in an enclosure that does not allow for proper
air circulation.
- Do not attempt to dismantle or modify LED arrays or driver board
assemblies as this may result in injury and will void the warranty.
- Ensure that the device is installed correctly and securely within the
aquarium before using it. Read and adhere to all important information
about the device.
- To avoid injury, do not come into contact with moving parts or hot parts,
such as heaters, lamps, etc.
- Warning! Never turn the lamp on when placed on tables or shelves.
Turning it on can ruin the surface, damaging the lenses and the lamp
itself.
IMPORTANT
Before installation, read all safety instructions & warnings.
HANGING LR/LF
The higher you hang your LR/LF over the water, the wider the light
spread but lower the light intensity. Wider and/or deeper tanks may
require hanging more than one LR/LF in order to provide sufficient light
coverage (fig. 2).
Ensure the LR/LF is securely fastened and will not fall or get wet.
Mount the lamp at least 23 cm above the water to prevent the device
from being exposed to excessive humidity/contact with the water. Water
damage is not covered under warranty.
The LR/LF has internal fans to disperse heat. For optimum performance,
do not operate the LR/LF in a completely enclosed hood. The minimum
distance to maintain between the rear side of the lamp and any object
that may prevent air from flowing outwards correctly must be no less
than 5 cm.
Description - fig. 2
A. LR/LF 9 inches (23 cm) or greater above the water.
ESTIMATING LR/LF LIGHT COVERAGE
LRs/LFs
24x24 inches ( 60x60 cm )
24 in ( 60cm ) high in the air
LRm/LFm
36x36 inches ( 90x90 cm)
24 in ( 60cm ) high in the air
INSTALLING THE AQAMAI LR/LF POWER SUPPLY
1. Choose a location free of excessive moisture and/or saltwater creep.
2. Mount your power supply where it won’t get wet. Include a “drip loop”
a tied loop of cord hanging down below the level of the electrical outlet.
That way, if water happens to run down the cord from the tank, it will drip
off onto the floor rather than into the outlet (fig. 3).
3. Now you can connect the main plug to the wall socket.
4. Once you’ve connected LR/LF to power supply on board LED light will
turn on in white colour for a while. If the LED light turns green, you can
proceed in connecting the lamp to the App.
Description - fig. 3
A.“Drip loop”.
AQAMAI APP - QUICK START GUIDE
Google Play and the Google Play logo are
trademarks of Google Inc.
App Store is a service trademarks of
Apple Inc.
Item
A
B
C
D
Quantity
1
1
1
1
Description
LR/LF light
Power supply
Power cord*
Hanging kit
WHAT’S INCLUDED - fig.1
*According your country standard
ENGLISH
aqamai.com/app