Hydmech M16A, Руководство пользователя

Страница: 39 / 76

3.1
Machine Power Disconnect is located at side of the main electrical and hydraulic enclosure. Style of disconnect may vary.
1. Ensure switch is in the OFF position.
2. Install padlock and lock it.
NORTH AMERICA STYLE
EUROPEAN STYLE
SECTION 3: MAINTENANCE & TROUBLESHOOTING
SAFETY DURING MAINTENANCE AND TROUBLESHOOTING
“Lock-out”, or “Lock-out Tag-out” are terms that refer to procedures taken to prevent the unexpected start-up, or other re
-
lease of energy, by a machine, whenever anyone is required to remove or bypass safety guards or devices, or whenever
anyone is required to place part of his body in a hazard area.
In almost all jurisdictions, it is required that owners of industrial equipment establish and post lock-out procedures. Know
and use the lock-out procedures of your company or organization. In the absence, of such posted procedures, use the
following procedure.
LOCK OUT PROCEDURE
Whenever work is to be performed on a machine, which requires removal or bypassing of safety guards or devices, or the
placement of part of anyone’s body in a hazard area, the following steps shall be taken:
1. Operator shuts down the machine.
2. The supervisor in charge of the machine must be informed of the intention to Lock-out the machine.
3. The Machine Power Disconnect Switch must be turned OFF, and locked in the OFF (0) position by means of
a padlock. The key for this padlock must be kept by the person performing the work on the machine. If more than one
person is performing work on the machine, then a multiple lock hasp shall be used, and each person shall apply his or her
own lock to the hasp.
4.
Prior to starting any work on the locked-out machine, the supervisor shall attempt to start the machine to ensure
that the lock-out device provides adequate protection. Operating controls must be reset to the “OFF” position after this
test.
6.
Work on the locked-out machine may now proceed.