Maintenance and Servicing Manual
FAM 200 FluidAqua Mobil
2
Safety Information and Instructions
2.1
Maintenance, Servicing and Troubleshooting
•
The inspection, maintenance and repair work specified in the manual is to be performed in a
timely, proper manner. Repair work to the unit which might prove necessary may not be
performed unless the requisite expertise and experience is present, otherwise the
manufacturer's specialists are to be consulted.
•
Work may only be performed by qualified personnel possessing the proper education and
training to this end.
•
Prior to commencing any such work, the operating personnel is to be informed about the work
to be done and a safety supervisor to be designated.
•
The repair area is to be cordoned off and secured insofar as this is necessary.
•
In the event that the unit is shut down for maintenance and repair work, measures are to be
taken to ensure that the unit is not switched back on by unauthorized personnel, e.g. by
securing the main and control switch using personal security locks. Make sure to remove the
key and store it in a safe place possessing restricted access.
•
Signs are to be affixed to indicate that maintenance, repair or cleaning work is being done to
the unit.
•
When removing components and assemblies make sure that no hazard is posed to the repair
crew by virtue of the unexpected movement of valves, pumps, etc. If this hazard cannot be
precluded, precautionary safety measures are to be taken, e.g. by propping or securing the
unit.
•
Components and assemblies of the unit aren't to be removed unless the individual charged
with this work has the requisite expertise to complete the task in a proper, safe manner. In
cases of doubt, be sure to contact the manufacturer for information or specialists.
•
If hoisting gear is needed to replace components or assemblies, make sure that the
components are secured by the gear and that the load suspension gear features the necessary
load-bearing capacity.
•
Only suitable lifting and load suspension gear is to be used which is in proper working order.
•
Do not work or stand under suspended loads!
•
When performing erection and installation at elevated heights, make sure to use safe climbing
aids and work platforms specifically designed for this purpose. Do not use part of the unit to
support your weight while climbing. All handles, steps, railings, pedestals, platforms, ladders
are to be kept free of dirt at all times.
•
Before cleaning the unit with high-pressure cleaners or other cleaning tools, be sure to
close/seal off all openings into which no cleaning agent may be allowed to enter for safety or
function reasons. This applies in particular to electromotors, switchgear, distributor boxes and
switch cabinets.
•
After concluding cleaning work make sure to remove all the covers or other material used to
seal the openings shut.
HYDAC Filtertechnik GmbH
en
Page 9
IuW FAM200 3373093a en.doc
2007-09-25
