Hyd-Mech VW18, Инструкция по безопасности и эксплуатации, Страница: 52 / 80

2.35
STEP 2 : SET FEED FORCE LIMIT
The Feed Force Limit is the maximum amount of force with which the head is allowed to push the blade into the
work-piece.
CUTTING SOLIDS
For cutting solids, the wider the section, the less FF should be set, to avoid blade overloading. See the graph below.
EXAMPLE: When cutting a solid which is 1/2 of machine capacity using the graph, locate 50% on the horizontal line and
travel upwards to the plotted line and then travel directly across to the vertical FF Setting line. The point that you have
arrived at shows a setting of 40% for a piece 50% of capacity.
% OF FF
SETTING
MAT’L WIDTH AS %
OF SAW CAPACITY
CUTTING STRUCTURALS: A reduced Feed Force Setting is used when cutting structurals.
(INDICATED
ON LABEL)