Hyd-Mech VW18, Инструкция по безопасности и эксплуатации, Страница: 20 / 80

2.3
OPERATION CONTROLS (STANDARD MACHINE)
The electrical buttons on the control panel allow for full manual and semi-automatic operation of the VW18. The operation
of each button is detailed on the following pages.
COUNT RESET:
•
Resets the number of pieces cut to 0 (Zero) on the LCD display.
MACHINE PARAMETERS:
•
Controls behavior of the machine and behavior of the optional equipment which may be installed.
•
Controls language in which to communicate with the operator.
•
Prior to making changes, care should be taken to ensure a complete understanding of each param-
eter and it’s effect on the operation of the saw.
MACHINE START:
•
Starts the hydraulic pump motor.
•
Machine disconnect switch must be in “ON” position.
•
When the hydraulic pump is idle for a period of time the pump will shut down. The pump will start up
again when any hydraulic function is activated. I.e. Head Forward, Left Vise Open.
CYCLE PAUSE:
•
In MANUAL MODE and SEMI-AUTO MODE, if CYCLE PAUSE is depressed the cycle pauses.
(The HEAD will STOP but the BLADE will continue to RUN)
•
To continue the cycle, depress CYCLE START push button.
BLADE SPEED DIAL:
•
This dial controls the blade speed which can be adjusted between 65 and 385 SFM (20-117 m/min).
The blade speed is displayed on the LCD display next to the BS abbreviation.
BLADE OFF (0) - ON (1):
•
This selector switch must be in the ON (1) position for the BLADE ON/OFF push-button to function.