Hyd-Mech VW18, Инструкция по безопасности и эксплуатации, Страница: 25 / 80

2.8
Setting Head Forward and Head Backward Limits
The machine can be setup to restrict the head movement in Semi-Auto mode between forward and backward limit
settings. During normal operating conditions where a complete through cut is required, the head forward limit should be
set beyond the material which is to be cut. Setting the head forward limit at any other position will result in a partially cut
piece.
The head back limit should be set so that the blade clears the material and fixed vise jaws. In cycle mode the head will
respect these two preset limits.
To Set Head Backward Limit
•
Position the head at the desired head backward position by pressing the HEAD FORWARD or HEAD BACK-
WARD buttons
•
Press the HEAD BACK LIMIT button.
To Set Head Forward Limit
•
Position the head at the desired head forward position by pressing the HEAD FORWARD or HEAD BACKWARD
buttons.
•
Press the HEAD FWD LIMIT button.
(Once HEAD FWD LIMIT push button is depressed the head will automatically move back to the HEAD BACK LIMIT)
Cycle Parameter Display
The machine is capable of displaying many parameters, not all of which can de shown on the screen at the same time.
Pressing the CYCLE PARAMETERS button will toggle the display of the parameters. The following is a list of available
parameters and the corresponding abbreviations as they are shown on the display.
Blade speed BS
Cut time CT
Blade tension BT
Head position HP
Amp draw of blade motor IBM
Pieces cut PC (To reset press COUNT RESET button)
Total run time of blade motor TOTALIZ
Machine Parameters
Machine parameters control the behavior of the machine, the type of optional equipment, which may be installed, and the
language in which to communicate with the operator. Modifying machine parameters may adversely effect the behavior of
the machine. Prior to making changes care should be taken to ensure a complete understanding of each parameter and
its effect on the operation of the saw.
To enter
MACHINE PARAMETERS
toggle the main switch located on the side of the panel OFF (0) and ON (1). Press
simultaneously and in sequence the
MACHINE PARAMETERS
and
MACHINE START
push buttons.
To move from parameter to parameter press the HEAD BACK LIMIT button.
To change the value of a parameter use the HEAD FORTH LIMIT button.
The COOL OFF button clears the parameter value.
To SAVE the parameters press simultaneously and in sequence the
MACHINE PARAMETERS
and
MACHINE START
push buttons.