Hyd-Mech VW18, Инструкция по безопасности и эксплуатации, Страница: 42 / 80

2.25
• The machine will perform the cut for Ang. B.
• Once the cut is complete the head will move to the HEAD BACK LIMIT position.
• The vises will begin to open and the head will rotate back to Ang. A.
• The machine will wait for the operator to position the material for Ang. A.
CYCLE
START
• Press COMMAND BLADE START.
COMMAND
ENABLE
BLADE
START
1
COMMAND
ENABLE
• Press COMMAND CYCLE START.
MACHINE PARAMETERS (POWER TILT OPTION)
Machine parameters control the behavior of the machine, the type of optional equipment, which may be installed, and the
language in which to communicate with the operator. Modifying machine parameters may adversely effect the behavior of
the machine. Prior to making changes care should be taken to ensure a complete understanding of each parameter and
its effect on the operation of the saw.
To enter MACHINE PARAMETERS toggle the main switch located on the side of the panel OFF (0) and ON (1).
Press simultaneously and in sequence the COMMAND ENABLE and SETUP push buttons.
To move from parameter to parameter press the ENTER button.
To change the value of a parameter use the NUMERICAL buttons or the NUMERICAL DIAL.
To move to the previous parameter use the ARROW button.
ENTER
To SAVE the parameters press simultaneously and in sequence the COMMAND ENABLE and SETUP push buttons.
COMMAND
ENABLE