Hyd-Mech DM-1215, Руководство по эксплуатации и обслуживанию

Страница: 9 / 136

1 − 1
Introduction and
technical
specifications
Foreword
Hydmech, in response to modern production techniques, has developed the new
DM-1215
.
This work tool has been designed to satisfy the wide range of cutting needs of a
modern workshop with simplicity and reliability, while at the same time comply­
ing with all EEC safety standards.
The
DM-1215 is structurally rigid, silent and safe: it produces a minimum of
waste (1.2 mm) while its great versatility makes it suitable for cutting various
materials such as stainless steel light alloys, aluminium, copper and bronze at
high speed and with high precision.
Its high cutting capacity, combined with the possibility of making inclined cuts
from 60° left to 45° right, make this model the ideal solution for satisfying the
wide strange of cutting needs of machine shops, turneries, structural steel shops
and engineering workshops.
We congratulate our clients on having chosen this product, which will give
effective and faithful service for many years, especially if the instructions
contained in this use and maintenance manual are carefully followed.
This cutting machine has been designed and made specifically for cutting
metallic materials.
Machine presentation
Functioning is Manual / Gravity-feed. After having checked the material in the
cutting vice, the operator must hold the cutting head control lever and press the
micro-switch to start-up the belt. The belt starts to move and the cuttting head
starts its descent. The speed is adjustable using the cutting head speed adjuster on
the control board.
The head cuts the material; after the cut, a limit switch stops the cutting cycle,
then the head lifts by the head lifting/lowering switch, and after having fed
material again a new cutting cycle is started with the push button from the control
board.
It is also equipped with MA (automatic vice), namely a pneumatic cylinder
applied on the vice that locks the material between the jaws: the vice opening/
closing button is on the control panel.
Warning
ÓÓÓÓÓÓÓ
ÓÓÓÓÓÓÓ
ÓÓÓÓÓÓÓ
ÓÓÓÓÓÓÓ
ÓÓÓÓÓÓÓ
ÓÓÓÓÓÓÓ
ÓÓÓÓÓÓÓ
1