Hyd-Mech DM-1215, Руководство по эксплуатации и обслуживанию

Страница: 46 / 136

5 − 12 45
Use and maintenance manual DM-1215
Angled cuts 45 ° to the right
Make sure the vice is positioned to the right of the 0° cutting slot.
slacken the locking lever as shown in the figure below;
position the vice to the right and lock the lever.
When positioning the vice to the left or right, make sure the moving jaw is be-
yond the 0
°
cutting slot to avoid any risk of collision with the blade downstroke.
Following the same procedure described above for 45 ° cuts to the left, now
position the head for 45 ° cuts to the right:
slacken the turntable lock/release lever;
pull the eccentric pin knob towards you (0 ° reference stop) and rotate slightly
to raise it;
rotate the head from right to left, till reaching the wished cant which is dis­
played by the grading on the rotating platform.
Relock the turntable lock/release lever;
make the cut in the required operating mode, following the preliminary safety
instructions set out in this chapter.
Attention