Hyco Zen Life LIFE3L, Инструкция по эксплуатации товара, Страница: 16 / 29

• Choose the supply source for source A and B, these are identified by port markers on
the base of the Crossover Valve. See diagram 6.
• Isolate mains supply, we recommend fitting a service valve (not supplied) close by to
aid any future maintenance.
• Ensure all tubing is pushed fully into PF connectors and that locking collars are
used to prevent inadvertent removal.
Source A
• T -off from the cold mains incoming water supply (t-section not supplied). Ensure
this is before the connection which has been made to facilitate connection to 3/8”
tubing.
• Make a connection from copper pipe to hose for source A using ½” BSP x 15mm
connector.
• Using the above steps, source A will provide mains cold water. See diagram 7.
Source B
• Select a suitable location for the drinking water filter housing ensuring easy access
for future maintenance.
• Do not locate the filter above an electrical socket or other electrical device.
• Remove drinking water filter cartridge from the filter head, secure the bracket to the
wall using the fixings supplied. Replace the filter cartridge into filter head.
• Use suitable length of ¼” tubing to connect remaining outlet of t-piece to drinking
water filter inlet marked ‘IN’.
• Use suitable length of ¼” tubing to connect drinking water filter outlet marked ‘OUT’
to hose for source B using ½” female to 1/4” PF and ½” x ½” coupler.
• Using the above steps, source B will provide filtered drinking water. See diagram 7.
Crossover Valve Outlet
• Take hose for Crossover Valve outlet and attach ½” x ½” coupler.
• Connect directly onto cold water tap connection hose of the Life tap.
• A ½” BSP x 15mm fitting is supplied but this can be discarded as this is not required
when installing a Crossover Valve.
16