OPERATING PROCEDURES
MP34.3200
16MAR10
RAISE
RAISE
UNDERSTAND OPERATOR’S MANUAL BEFORE USING. BLOCK FRAME AND TIRES
CAUTION!
SECURELY BEFORE REMOVING TIRES OR CRAWLING UNDER VEHICLE.
LIGHT
RESET
HOME
STOP
HWH SYSTEMS CONTROL
R
LOWER
LOWER
RAISE
LOWER
LOWER
RAISE
MANUAL HYDRAULIC LEVELING
LEVELING SYSTEM.
OF THE VEHICLE WHILE OPERATING THE HYDRAULIC
CAUTION:
KEEP PEOPLE AND OBJECTS CLEAR
ON
SENSING
LIGHT (4)
LEVEL
OFF
3. At this time, the operator may want to check the jacks
LEVEL
HYD
ON
OFF
JACK DOWN
WARNING
LIGHT (4)
HOME PAGE
AUTO STORE
BUTTON
LEVEL BUTTON
MANUAL HYD
HOME PAGE
pushing the "AUTOMATIC HYD LEVEL" button again.
Push the "HOME" button and correct the problem before
when the "AUTOMATIC HYD LEVEL" button if pushed.
park brake are not on, a message will appear on the screen
to use automatic hydraulic leveling. If the ignition and/or the
The ignition key must be on and the park brake must be set
NOTE: Manual leveling and automatic store can only
be started when the "HOME" page is being displayed.
Level the vehicle according to level sensing lights. A lit
level sensing light indicates that side, end or corner of the
vehicle is low. When all level sensing lights are out the
vehicle is level.
The "RAISE" buttons are used to extend the jacks and raise
the vehicle. The "LOWER" buttons are used to retract the
jacks. Each set of buttons operate a pair of jacks, front, rear
left or right side. The RAISE and LOWER buttons are
momentary buttons. The jacks will extend or retract while
the buttons are being pushed.
The Jack Down Warning Lights will come on as there
respective jack extends approximately 1 inch.
1. Turn the ignition key on and set the park brake.
2. Push the "MANUAL HYD LEVEL" button on the
"HOME" page.
and place a pad under each jack at this time, if necessary.
4. Dump air from the vehicle suspension at this time.
Refer to the vehicle manufacturer for air dump instructions.
5. Push and hold the "RAISE" buttons as necessary to
raise the vehicle according to lit LEVEL SENSING lights.
If a side LEVEL SENSING light is on, extend that pair of
jacks to turn the side light out first before leveling the
vehicle from front to rear.
6. Any jack(s) not used for leveling should be extended to
the ground to stabilize the vehicle. Use the front and/or
rear "RAISE" button to accomplish this. Jacks extended to
stabilize the vehicle should lift the vehicle at least 3/4 of an
inch.
IMPORTANT: DO NOT continue to push a "RAISE"
button for more than 10 seconds after that pair of
jacks are fully extended.
7. When the leveling and stabilizing procedure is complete,
push the "HOME" button and turn the ignition off or proceed
with other functions.
IMPORTANT: Although the jacks can be retracted using
the "LOWER" buttons the "AUTO STORE" button on the
"HOME" page should be used to retract the jacks.
Always use the "AUTO STORE" button when
preparing to travel.
