OPERATING PROCEDURES
GENERAL INSTRUCTIONS
The Hydraulic Leveling system, cannot be activated
MP34.0901
16MAR10
Turn the ignition to the "ON" or "ACC" position to turn the
SYSTEM CONTROL panel on.
Push the "HOME" button to return the SYSTEM CONTROL
panel to the HOME PAGE. Any function that is to be operated
from the SYSTEM CONTROL panel can only be accessed
from the HOME PAGE. Individual screen functions are
Push the "STOP" button to stop any function. Pushing the
"STOP" button will turn the SYSTEM CONTROL panel off.
if the park brake is not set.
Maintain adequate clearance in all directions for vehicle,
room extensions and generator slide, doors, steps, etc..
Vehicle may move in any direction due to raising and
lowering of vehicle during leveling, settling of vehicle,
equipment malfunction etc..
explained in this section.
The SYSTEM CONTROL screen will exhibit messages to
the operator when there is a problem or malfunction in the
system or when a function cannot be used. The "HOME"
button must be pushed to acknowledge the message. The
malfunction or situation must be corrected before proceeding.
APPEARS ON THE CONTROL SCREEN, IT IS THE
CAUTION:
ANYTIME A "WARNING" MESSAGE
OPERATORS RESPONSIBILITY TO CORRECT THE
PROBLEM TO ENSURE SAFE OPERATION OF THE
VEHICLE AND IT’S SYSTEMS.
PREPARATION FOR TRAVEL
1. When either leveling system has been used, push the
"AUTO STORE" button to retract the jacks and/or return
the system to the traveling mode. It is a good idea to
always, push the "AUTO STORE" button after starting the
engine. This will ensure thermal expansion of the fluid in
the hydraulic leveling system will not cause a jack down
indicator to come on while traveling.
2. Check that all four leveling jacks are fully retracted
to the STORE position.
3. If the flashing "STORE" light does not shut off after
three to four minutes there may be a malfunction. Bring
up the correct STATUS page to determine which jack
may not be retracted. The jacks may take longer to
retract in cold weather.
4. The SYSTEM CONTROL PANEL should be
on when traveling.
5. Check that the vehicle is at the proper ride height
for traveling.
CAUTION:
DO NOT MOVE THE VEHICLE WHILE
THE LEVELING JACKS ARE STILL IN CONTACT WITH
THE GROUND OR IN THE EXTEND POSITION. THIS
VEHICLE IS EQUIPPED WITH STRAIGHT-ACTING JACKS.
MOVING THE VEHICLE WITH THE LEVELING JACKS
EXTENDED CAN CAUSE SEVERE DAMAGE TO THE
JACKS AND OR THE VEHICLE AND CREATE A DRIVING
HAZARD. DO NOT RELY SOLELY UPON WARNING
LIGHTS. IT IS THE OPERATOR’S RESPONSIBILITY TO
CHECK THAT ALL THE JACKS ARE FULLY RETRACTED
INTO THE STORE/TRAVEL POSITION AND THE VEHICLE
IS AT THE PROPER RIDE HEIGHT FOR TRAVELING.
CONTACT MANUFACTURER TECHNICAL SERVICE
BEFORE MOVING A VEHICLE THAT IS NOT AT
PROPER TRAVEL HEIGHT.
Place a pad or block under each jack if the ground is too
soft to support the vehicle or when parking on soft asphalt.
