HWH 200 series, Руководство оператора

Страница: 7 / 25

OPERATING PROCEDURES
MP35.553C
08DEC03
ROOM RETRACT PROCEDURE
2. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted. halt the operation of the room.
IMPORTANT: Room-locking devices should be locked
while traveling.
6. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
1. Insert the KEY and turn the KEY SWITCH on the ROOM
OPERATOR’S PANEL to the "ON" position.
4. Remove the KEY to prevent undesired
PANEL to the "OFF" position.
3. Turn the KEY SWITCH on the ROOM OPERATOR’S
5. Engage all room locking devices.
NOTE: Releasing the ROOM CONTROL SWITCH will
operation of the room.
HWH Customer Service for assistance 1-800-321-3494.
room. DO NOT reverse direction of the room, contact
room control switch immediately. DO NOT force the
If either side of the room stops moving, release the
after the room is fully retracted or stops moving.
in the "RETRACT" position for more than ten seconds
Do not hold the ROOM CONTROL SWITCH
reversed, DO NOT retract the room until the room
the room. If the direction of the room has been
of the room may be reversed, but watch for binding of
the room is fully retracted. If necessary, the direction
of the room, do not reverse direction of the room until
During normal operation
Hold the switch to "RETRACT" three or four seconds
after the room is fully retracted. This assures proper
has been fully extended.
pressurization of the cylinders.
IMPORTANT:
NOTE:
CLEAR OF ROOM WHEN OPERATING.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
jacks when the room is extended is not recommended.
IMPORTANT: Extending or retracting any leveling