HWH 200 series, Руководство оператора

Страница: 6 / 25

OPERATING PROCEDURES
ROOM EXTEND PROCEDURE
to fully extend the room.
NOTE: Make sure there is adequate clearance
NOTE: If the MANUAL RETRACT WINCH is attached to
CLEAR OF ROOM WHEN OPERATING.
the room remove it before extending the room.
2. Unlock all room-locking devices.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
ROOM-LOCKING DEVICES LOCKED OR THE MANUAL-
RETRACT WINCH ATTACHED CAN CAUSE PERSONAL
1. Follow the LEVELING AND STABILIZING PROCEDURE.
when the room is extended is not recommended.
IMPORTANT: Extending or retracting any leveling jacks
IMPORTANT: It is recommended to level and stabilize
the vehicle before extending the room.
RESPONSIBILITY TO ENSURE THAT ALL ROOM-LOCKING
DEVICES AND THE MANUAL-RETRACT WINCH ARE
DISENGAGED BEFORE OPERATING THE ROOM.
INJURY AND VEHICLE DAMAGE. IT IS THE OPERATOR’S
CAUTION:
OPERATING THE ROOM WITH ANY
the operation of the room.
IMPORTANT: Do not use the room extension support
when the vehicle is supported by the leveling system.
7. Turn the KEY SWITCH to the "OFF" position and remove
the key to prevent undesired operation of the room.
MP35.551
08DEC03
CONTROL SWITCH in the "EXTEND" position
after the room is fully extended or stops moving.
in the "EXTEND" position for more than ten seconds
of the room, do not reverse direction of the room until
after the room is fully extended. This assures proper
Hold the switch to "EXTEND" three or four seconds
Do not hold the ROOM CONTROL SWITCH
During normal operation
the room is fully extended. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT re-extend the room until the room
If either side of the room stops moving, release the
6. To extend the room, press and hold the ROOM
NOTE: Releasing the ROOM CONTROL SWITCH will halt
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
room control switch immediately. DO NOT force the
until the room is fully extended.
pressurization of the cylinders.
has been fully retracted.
IMPORTANT:
NOTE:
3. Turn the ignition switch to ACCESSORY.
4. Press the "ON" button on the leveling system control
panel if the POWER ON LIGHT is not illuminated.
5. Insert the KEY and turn the KEY SWITCH to
the "ON" position.
8. Press the "OFF" button on the leveling system
control panel.
9. Turn off the ignition switch.