CVH8, HVH8, TVH8, VA9, HVA9, TVA9: APPLICATION GUIDELINE & SERVICE MANUAL
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
27
9. With using a slot screwdriver, lift up the on the side tab to pry the
cover off from the RTV. Be sure not to break the tab.
A210662
10. It may be necessary to leverage the screwdriver against cover next
to tab so as not to break the tab while loosening.
A210663
11. Once Cover is loosened on one side, use screwdriver along freed
edge to remove.
A210664
12. Remove cover, unplug old harness, plug in new harness, verify
bushing is reinstalled and plug leads leave the terminal box through
the bushing; reinstall cover pushing one side down then the other.
NOTE: DO NOT SCRAP SEALANT
A210665
13. Reinstall compressor sound blanket making sure discharge
thermistor and compressor power harness are routed as they were
from the factory.
14. Route compressor power harness to new double loop wire tie and
then to the wire retainers in tube sheet (route as they were originally
to make sure they will not contact fan blade) and then route into
control box and reinstall two control box screws. (See image
below)
A210666
15. Reinstall service panel.
16. Route compressor harness choke to left hand side of the top of
control box and push in wire tie. Pull wires tight as they enter
control box and tighten second wire tie.
17. Reconnect compressor power harness to the inverter.
NOTE
:
Reference enclosed wiring diagrams and unit wiring diagrams in
Owner’s Manual to aid in reattaching electrical connections.
18. Reinstall control box cover.
