P/N 0520677_W
1-17
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Freedom Line Reach-in
Figure 7B. Joining Sequence
RFL / RFLN
7
Loosely insert
Cap Screw – 5
with
Lock Washer – 6
into each nut
retainer following the sequence
shown in Figure 7A.
Do not tighten fully.
A. Fasten bottom fronts together,
but tighten only until front panels
touch.
B. Move to the bottom back position
and join (2 places).
C. Join at the top front position.
D. Go to the middle back wall position
and join.
E. Join at the lower back wall.
F. Finally, join at the top back wall
position.
Following the same sequence,
tighten each cap screw fully until
the merchandisers are joined with a
snug fit and gaskets are compressed.
8
Refer to Section 1 of the
Reach-In Installation and Service
Manual to install splashguard
brackets and bumpers. Section 3
provides direction for installing
splashguards, including splashguard
Splice Connector – 8.
Nut Retainer
Alignment Pin
