PRODUCT INSTALLATION MANUAL
DD13 2T SERVICE DELI
_________________________________________________________________________________________________________________________
Page 28
Hussmann
Appendixes
Appendix 1
Wiring diagrams
–
Supplied with each case.
Appendix 2
Product Engineering Datasheet
–
Supplied with each case.
Appendix 3
Setting Table
–
Supplied with each case.
Appendix 4
Attaching case ends
Appendix 5
Top glass horizontal adjustment
Appendix 6
Front glass door camber adjustment
Case ends are normally fitted in the factory; however, they occasionally need to be attached to a case on-site. Use this
procedure when an end attaches to a single case and when it is common to two cases.
Ensure that correct and appropriate manual handling techniques are applied when fitting a patch end.
Cases must be sealed before attaching case ends. To seal cases, refer to sealing case joins on page 10.
SEQUENCE OF OPERATIONS
1. Carefully run a knife around the inside rim of the end trim, taking care not to scratch the case end stainless steel
surface, and remove the case end membrane.
2. Apply silicone around the perimeter of case E/Frame 10mm in from the edge plus apply to center of E/Frame and
line up the ends with the case. Red line in Fig 19 denotes the silicone application.
3.
Fig (19) Silicone application
