Husqvarna VIKING Amber Air S 600, Руководство пользователя

Страница: 25 / 64

Threading the Needles
Threading the Left Overlock Needle (A)
2
1
3
5
6
8
4 7
6
2 3
5
8
7
4
9
1
9
Yellow threading path
Blue threading path for Safety Stitches no 1 and 4
A B
C D E
Needle A
Note: Raise the presser foot to release the tension discs.
Note: Make sure to raise the telescopic thread stand to its highest
position (illustration shows a “cropped” thread stand).
1. Place a thread spool on the left spool pin. Pull the thread
through the left thread guide from back to front.
2. Carefully slide the thread under the pre-tension thread
guide from right to left.
3. Pull the thread along the threading slit. Using both hands,
insert the thread between the tension discs.
4. Pull the thread down along the slit and pass it to the left
through the thread path.
5. Slip the thread into the middle slot on the thread guide.
6. Continue threading into the slot on the take-up lever.
7. Then slip the thread into the second slot on the next
thread guide.
8. Place the thread in the third slot on the thread guide
above the needle clamp.
9. Place the thread behind the guide above the A/B needles.
Thread the eye of the needle. Use the needle threader
(see page 31) to make needle eye threading easier. Pull
about 4" (10 cm) of thread through needle eye to hang
free.
Place the thread to the back, under the presser foot.
Close the front cover and lower the presser foot to start
sewing.
4 Threading 25