Husqvarna VIKING Amber Air S 600, Руководство пользователя

Страница: 12 / 64

Attach the Extension Table
1
2
3
A
To use the extension table, remove the flat bed extension
cover (see Flat Bed Extension / Free Arm).
1. Fold out the legs of the extension table.
2. Place the extension table around the free arm. Fit the pin
(A) of the extension table into the corresponding hole on
the machine. Push the extension table towards the
machine to lock it in place.
3. If needed, turn the leveling screws at the bottom of the
legs to make the extension table stand sturdy.
To remove the extension table, carefully push it to the left.
Change Between Cutter Cover A and
Coverstitch Table B
B
C
D
E
A
For coverstitch and chainstitch sewing Coverstitch Table B
should be used. You can easily change between Cutter Cover
A (mounted upon delivery) and Coverstitch Table B.
Open the front cover.
Push the release lever (A) down and pull Cutter Cover A
towards you to remove it.
Place Coverstitch Table B underneath the front lid. Slide the
release lever, from above, into the slot in the front cover (B).
Fit the two pins (C) of Coverstitch Table B, from underneath,
into the holes (D) of the cover.
Push towards the front cover until the release lever clicks in
place into the slot on the front cover (E).
Note: Whether you are using Cutter Cover A or Coverstitch Table B,
they are attached and removed in the same way.
Presser Foot Lift
A
Raise the presser foot by raising the presser foot lifter (A) at
the right side of the machine. Pressing the lifter up puts the
presser foot in extra lift position.
Always raise the presser foot lifter when threading. When
raised, the tension disks open and the threading becomes
easier.
Note: The machine will not sew if the presser foot is raised. Lower the
presser foot before starting to sew.
12 2 Preparations