Husqvarna VIKING Amber Air S 600, Руководство пользователя

Страница: 16 / 64

Upper Looper Position
1
2
Deactivate the upper looper for coverstitch and chainstitch
sewing.
Deactivate the Upper Looper, Position B
Open the front cover.
Turn the handwheel until the upper looper is in its lowest
position.
Slide the Upper Looper Positioning lever to the left to
deactivate the upper looper, Position B (1).
Activate the Upper Looper, Position A
Open the front cover.
Slide the lever to the right to activate the upper looper,
Position A (2).
Threading/Sewing Lever
Threading Position
Turn the handwheel toward you
Threading Position
Before threading the loopers, the machine should be set in
threading position. Then the loopers and looper pipes are set
in the correct position for threading.
Raise the presser foot to release the tension discs.
Set the Threading/Sewing lever in "Threading" position by
sliding it to the left.
Turn the handwheel slowly toward you until it clicks and the
needles/loopers are locked in threading position.
Thread the needles (page 25) and loopers (page 32 ) as
described in respective section.
Sewing Position
Sewing Position
When the threading is complete, the machine should be set
in sewing position.
Set the Threading/Sewing lever in "Sewing" position by
sliding it to the right.
Pull 4˝ (10 cm) of the thread under the toe of the foot, and
back between the presser foot and the upper cutter.
Close the front cover and lower the presser foot.
Stitch Finger Lever
A
B
C
The stitch finger (A) is used to stabilize the fabric edge when
forming stitches. The stitch finger lever should be set to "N"
for all standard overlock sewing (B). To sew rolled edge you
need to retract the stitch finger by setting the stitch finger
lever to "R" (C).
When moving the stitch finger lever, be sure to push the
lever as far as it will go in each direction.
16 2 Preparations