Husqvarna F1303V1, Руководство пользователя

Страница: 84 / 140

14 WHEELS, TIRES
82
E01125-12
–
Pull the rear wheel back and mount wheel spindle
3
with the washer and chain adjuster
4
.
Guideline
Mount left and right chain adjusters
4
in the same
position.
–
Mount nut
2
with washer.
–
Make sure that the chain adjusters are positioned cor-
rectly on the screws.
–
Check the chain tension. ( p. 65)
–
Tighten nut
2
.
Guideline
In order for the rear wheel to be correctly aligned, the
markings on the left and right chain adjusters must be
in the same position relative to reference markings
B
.
Nut, rear wheel
spindle
M14x1.5 90 Nm (66.4 lbf ft)
–
Position wheel speed sensor
5
in the hole.
–
Mount and tighten screw
6
.
Guideline
Screw, wheel
speed sensor
M6 7 Nm (5.2 lbf ft)
Loctite
®
243™
F02843-10
(Option: Cast wheels)
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
1
and contact sur-
faces
A
of the spacers.
Long-life grease ( p. 130)
–
Clean the thread of the wheel spindle and axle nut.
–
Clean and lightly grease the wheel spindle.
Long-life grease ( p. 130)
–
Clean the contact areas on the brake caliper bracket and
link fork.
–
Mount the damping rubber pieces and rear sprocket car-
rier on the rear wheel.
–
Insert the narrow spacer into the side of the rear
sprocket.
–
Insert the wide spacer into the side of the brake disc.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.