Husqvarna F1303V1, Руководство пользователя

Страница: 81 / 140

WHEELS, TIRES 14
79
F02842-10
(Option: Cast wheels)
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact sur-
faces
A
of the spacers.
Long-life grease ( p. 130)
–
Insert the spacers.
F03836-11
–
Clean the thread of the wheel spindle and screw
2
.
–
Clean and lightly grease the wheel spindle.
Long-life grease ( p. 130)
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle
M8 20 Nm (14.8 lbf ft)
–
Position wheel speed sensor
3
in the hole.
–
Mount and tighten screw
4
.
Guideline
Screw, wheel
speed sensor
M6 7 Nm (5.2 lbf ft)
Loctite
®
243™
–
Position the fender, and mount and tighten screws
5
with the washers.
Guideline
Screw, fender on
axle clamp
M6 12 Nm (8.9 lbf ft)
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Take the motorcycle off the front lifting gear. ( p. 54)
–
Remove the rear of the motorcycle from the lifting gear.
( p. 52)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
6
.
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)