Husqvarna DXR300, Руководство оператора

Страница: 24 / 60

24 –
English
STARTING AND STOPPING
Before starting
The following points should be checked when working at a
new site and every morning before starting:
• Carrying out daily inspections.
• Examine the machine for transport damage.
• Check that the machine’s safety features are intact. Refer
to 'The machine’s safety features” in the 'General working
instructions” chapter.
• Check that the power cable and operating cables are
intact and correctly dimensioned.
• Check that the mains voltage is compatible with the
machine and that the correct fuses are used.
• Always connect the machine through an ground fault
circuit interrupter with personal protection, i.e. an ground
fault circuit interrupter that trips at an ground fault of 30
mA.
• Make sure the emergency or machine stop button is reset.
• Check that no tools or other objects have been left lying
on the machine.
Starting
Connect the machine
• Connect the machine to a 3 phase power supply.
• Turn on the main switch on the machine.
Starting the remote control
• Turn the switch to the ON position (I). In this position the
remote control is supplied with current. The light emitting
diode on the remote control flashes rapidly with a blue
light when it is searching for contact. When it flashes with
a longer interval the machine is in standby mode.
• If a function is not working or needs attention, an error
message appears on the display in conjunction with start-
up. Refer to 'Error messages” in the 'Trouble shooting”
section.
Starting the electric motor
• The electric motor is started by pressing the start button.
• If several machines are used at the same workplace there
is a risk of mixing up the remote controls.
Press the horn to see which machine is connected to the
remote control. The machine will beep and flash three
times. Do not activate the remote control before you have
ensured that the correct machine is being operated.
Activating controls
• To activate the remote control’s operating functions press
the left button on the right joystick. The remote control is
now in work mode. The light emitting diode on the remote
control has a permanent blue light.
• If no command is given within three seconds the operating
functions are locked. To return to work mode, press the left
button on the right joystick.
• The control lever must be in neutral position.
Stopping
• Manoeuvre the arm system down and allow it to rest
against the ground.
• Set all controls into neutral position.
• Press the stop button.
• Put the main switch into the OFF position (O).
Inspection after work
It can be beneficial to carry out the daily inspection after
finishing work. Detecting damage in time can prevent a
shutdown on the following day.