Husqvarna AUTOMOWER 105, Руководство оператора

Страница: 74 / 84

74 - English
9. TROUBLESHOOTING
9.4 Finding breaks in the loop wire
Breaks in the loop wire are usually the result of
unconscious physical damage to the wire such as
when gardening with a shovel. In countries with ground
frost, even sharp stones that move in the ground can
damage the wire. Breaks can also be due to the high
tension in the wire during installation.
Mowing the grass too low right after the installation can
damage wire insulation. Certain damage to the
insulation may not cause disruptions until several
weeks or months later. To avoid this, always select the
maximum cutting height the first weeks after
installation and then lower the height one step at a
time every second week until the desired cutting height
has been reached.
A defective splicing of the loop wire can also lead to
disruptions first several weeks after the splice was
done. A faulty splice can, for example, be the result of
the original coupler not being pressed together hard
enough with a pair of pliers, or a coupler of lower
quality than original coupler has been used. Please
first check all known splices before further
troubleshooting is done.
A break can be located by gradually halving the
distance of the loop wire where the break may have
occurred until there is only a very short section of the
wire left.
1. Make sure the indicator lamp in the charging
station flashes blue, which indicates a break in
the boundary loop. See
9.2 Indicator lamp in the
charging station on page 71.
2. Check that the boundary wire connections to the
charging station are properly connected and not
damaged. Check that the indicator lamp in the
charging station is still flashing blue.
3012-965
3018-049