Husqvarna 343F, Руководство по ремонту

Страница: 41 / 63

40
5
503 80 17-01
Angle gear
Shaft
The shaft contains a drive axle guide
that is easily replaced. It can be
dismantled once the plastic sleeve (B)
has been removed.
Centre the axle control in the shaft
when a new one is fitted.
Fit a new O-ring to ensure a good seal.
Shaft
The shaft contains a long plastic guide
to prevent vibrations in the drive axle.
The guide (A) is easily removed for
replacement.
Bend away the plastic sleeve (B) and
the O-ring (C) using a knife and pull the
drive axle guide out from the shaft.
When replacing the axle guide, the
replacement must be inserted into the
shaft so that the distance is the same to
the two ends of the shaft.
When fitting, a new O-ring must be
used. To avoid damage from the sharp
edges of the slits in the gearbox, the
following assembly procedure is
recommended:
1. Place the plastic sleeve (B) in
position in the gearbox.
2. Slide the O-ring (C) onto the plastic
sleeve.
3. Slide the shaft and guide (A) into
position.
Lubricate the drive axle with grease no.
503 80 17-01 when assembling.