Husky HU80220, Руководство оператора

Страница: 14 / 30

12 — English
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off motor, wait for all moving parts to stop, and
disconnect plug from power source. Failure to follow
these instructions can result in serious personal injury or
property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an authorized service center.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
OPERATION
STORING THE PRESSURE WASHER
See Figure 15.
When not in use, store the pressure washer indoors in a low
traffic area.

Depress the handle release button. This will allow the
handle to retract. If the handle does not lower on its own,
apply a light pressure to push the handle down.
NOTE: Do not loosen the locking collar when retracting
or extending the handle.

When the pressure washer is needed again, depress and
hold the handle release button while pulling up on the
handle to restore it to normal operating position.
For winterizing and long-term storage:

Disconnect the water connection, if necessary.

Start the pressure washer and allow it to run for a few
seconds to eliminate any water remaining in the pump.

Coil the hoses and place in the hook-and loop strap on the
unit’s handle. Do not allow the hose to become kinked.
 Store the unit and accessories in an area that does not
reach freezing temperatures. Do not store near furnace
or other sources of heat that could dry out the pump
seals.
CAUTION:
The use of a pump protector is recommended to prevent
cold weather damage during storage over the winter
months.