HURST P 630 SG, Инструкция по эксплуатации

Страница: 29 / 44

29
11.3.1 Replacing and cleaning the air filter
Procedure:
If present, remove the rear side panel of the hydraulic power unit, in that the fixing clip and
the side panel are removed.
1. Unscrew both bolts from the air filter cover and remove the cover.
2. Remove the foam air filter insert from the cover.
3. Take the paper air filter insert from the air filter housing.
4. Check both air filter inserts and replace if damaged. The paper air filter insert must always
be replaced at planned intervals.
5. Clean the air filter inserts if reusing them.
Paper air filter insert : Tap out the paper air filter insert a few times on a hard surface to
remove dirt or blow compressed air [not more than 207 kPa (2.1 kg/cm )] from the air filter
housing side through the filter insert. Never attempt to brush out dirt because it would be
pressed in by the bristles. Replace the paper air filter insert if it is exceedingly dirty.
Foam air filter insert: Clean in warm soapy water, rinse and allow to dry thoroughly.
Or clean in non-flammable solvent and let dry. Do not introduce any oil to the foam air
filter insert.
6. Wipe away dirt from the inside of the air filter housing with a damp cloth. Ensure that dirt
does not penetrate the air duct leading to the carburettor.
7. Then re-fit the filter.
NOTE:
Keeping the air filter in good condition is extremely important. Penetrating
dirt leads to damage and wear in the engine in case of incorrect installation,
incorrect damage or unsuitable filter inserts.
Always keep the air filter insert clean.
Air filter cover
Bolts
Foam air filter insert:
Paper air filter insert:
Air filter housing